In the case of a destructive device, the Director may authorize other means of identifying that weapon upon receipt of a letter application from you, submitted in duplicate, showing that engraving, casting, or stamping (impressing) such a weapon would be dangerous or impracticable.Īny part defined as a machine gun, firearm muffler, or firearm silencer in Sec. The Director may authorize other means of identification upon receipt of a letter application from you, submitted in duplicate, showing that such other identification is reasonable and will not hinder the effective administration of this part. In the case of any semiautomatic assault weapon manufactured after September 13, 1994, you must mark the frame or receiver RESTRICTED LAW ENFORCEMENT GOVERNMENT USE ONLY or, in the case of weapons manufactured for export, FOR EXPORT ONLY, in a manner not susceptible of being readily obliterated, altered, or removed.įor weapons manufactured or imported on and after January 30, 2002, the engraving, casting, or stamping (impressing) of the special markings prescribed in this paragraph (a)(3) must be to a minimum depth of.003 inch. This information must be placed in a manner not susceptible of being readily obliterated, altered, or removed.įor additional requirements relating to imported firearms, see Customs regulations at 19 CFR part 134.Ī firearm frame or receiver that is not a component part of a complete weapon at the time it is sold, shipped, or otherwise disposed of by you must be identified as required by this section.
#Free gun serial number information serial number#
The serial number must be placed in a manner not susceptible of being readily obliterated, altered, or removed, and must not duplicate any serial number placed by you on any other firearm.įor firearms manufactured or imported on and after January 30, 2002, the engraving, casting, or stamping (impressing) of the serial number must be to a minimum depth of.003 inch and in a print size no smaller than 116 inch and.
0 kommentar(er)
